banner
Oct 21, 2021
4 Views
0 0

How and how to quickly dismantle old coatings during repair

How and how to quickly dismantle old coatings during repair

An equally difficult stage of repair than finishing is the dismantling of old plaster, tiles, screeds. This can take a lot of time. But if you find the right tool for each type of coating, you can finish the rough work much faster.

Removing thin layers of putty from concrete slabs

Thin layers of putty can be removed from smooth, hard substrates with a universal scraper, into which blades for a mounting knife are inserted. They can knock down layers of 1-5 mm very quickly and quietly.

How and how to quickly dismantle old coatings during repair

You need to use glasses to work with such a scraper. Be sure to use high quality hardened blades. Cheap ones break off the corners, and like bullets fly away in different directions, so it’s better not to save money so as not to get injured.

How and how to quickly dismantle old coatings during repair
How and how to quickly dismantle old coatings during repair
How and how to quickly dismantle old coatings during repair

Please note that a sharp blade removes the thinnest layers, and a blunt one can take 3-5 mm thick enough. In addition, the blunt is capable of working on rough surfaces. It is also easy for them to remove the remains of linoleum.

How and how to quickly dismantle old coatings during repair

In order for the tool to work, you need to constantly turn it over to the other side after a couple of postings. Otherwise, the edge will be worn out in a minute.

Removal of screed, self-leveling floor, tiles, plaster

Thick layers of old coatings can be knocked down with a hammer drill. However, his blows spread over the floor slabs, so that the neighbors in several entrances will find out about the dismantling being carried out. It is better to work with a punch where there are no other options to knock down the old coating.

How and how to quickly dismantle old coatings during repair
How and how to quickly dismantle old coatings during repair

Aligning corners, protrusions

A similar work as with a perforator can be done with a grinder with a diamond grinding bowl. It’s much quieter but comes with a huge dust emission. Therefore, a construction vacuum cleaner must be connected to it.

Any discs for angle grinders on Aliexpress with a discount – http://alii.pub/61bjly

How and how to quickly dismantle old coatings during repair

The bowl allows you to grind off all irregularities. It is especially convenient to use if you need to trim curved corners by smoothing out the protrusions. This will further reduce the consumption of plaster.

Rough quick dismantling

The stripping machine does very high quality dismantling.

How and how to quickly dismantle old coatings during repair

It works like a grinder with a diamond blade, but has an impact. Due to this, it literally rips off, and at the same time knocks down from the bases of the coating. Even if it is uneven, it will allow you to knock out poorly adhered plaster or screed from the recesses.

How and how to quickly dismantle old coatings during repair

The peeling machine is also capable of removing waterproofing. It turns everything into dust and small crumbs. That is, you can use a less powerful vacuum cleaner for it than when working with a diamond tool.

How and how to quickly dismantle old coatings during repair

Any discs for angle grinders on Aliexpress with a discount – http://alii.pub/61bjly

Watch the video

How to make a speed controller for a power tool without knowledge of electronics – https://sdelaysam-svoimirukami.ru/8044-kak-sdelat-reguljator-oborotov-jelektroinstrumenta-bez-znanija-jelektroniki.html

Article Categories:
Interesting
banner

Leave a Reply